Shop4WindowFilms - Window Film Fitting Instructions
You will require a share blade or knife, a squeegee, spray bottle and
some tissues. Ensure that the film is kept clean whilst handling.
DO NOT fold or crease the film.
THE FILM IS USUALLY APPLIED TO THE INSIDE OF YOUR WINDOW
01.Thoroughly
wet the glass with clean water containing detergent. 
02.Scrape
the window clean using a window scraper or similar tool. 03.Squeegee the window and dry with lint
free a tissues/cloth. Wipe around the edge of the glass and frame. Re
wet the glass using the same solution.
04.Seperate
the clear liner from the film using 2 pieces of sticky tape. 
05.Thoroughly soak the adhesive side of the
film (The side the liner was attached to).
06. Place the adhesive side of the film on the
glass leaving an overlap all the way around the edge of the frame.
07. Using the same water and soap solution.
Wet the surface of the film and squeegee following this pattern.
08. Trim the overlap with a Stanley knife or
sharp blade leaving a 1-2mm gap.
09. Wet the film again and sqeegee using the
same pattern as before.
10.
Wipe any excess water from the film and around the frame.