Window Film Fitting Instructions

You will require a share blade or knife, a squeegee, spray bottle and some tissues. Ensure that the film is kept clean whilst handling.
DO NOT fold or crease the film.
THE FILM IS USUALLY APPLIED TO THE INSIDE OF YOUR WINDOW

03.Squeegee the window and dry with lint free a tissues/cloth. Wipe around the edge of the glass and frame. Re wet the glass using the same solution.

04.Seperate the clear liner from the film using 2 pieces of sticky tape.

05.Thoroughly soak the adhesive side of the film (The side the liner was attached to).

06. Place the adhesive side of the film on the glass leaving an overlap all the way around the edge of the frame.

07.Using the same water and soap solution. Wet the surface of the film and squeegee following this pattern.

08. Trim the overlap with a Stanley knife or sharp blade leaving a 1-2mm gap.

09. Wet the film again and sqeegee using the same pattern as before.

10. Wipe any excess water from the film and around the frame.